AUSTRALIAN MONITOR MX 81 Spécifications télécharger pdf (Page 5)

MX81 INSTALLATION & OPERATION MANUAL PAGE 5

REAR PANEL

CHANNEL INPUTS

Channels 1 to 6 have two inputs, channels

7-8 only have an XLR input:

XLR input - This is a balanced input.

It accepts mic or line level signals

depending on the front panel gain

switch position. The XLR will also

have +15V phantom power if

selected on the switch.

RCA input - This is an unbalanced line

level input. The two RCA sockets are

summed to mono internally.

REC OUT

The REC OUT output is on unbalanced

RCA connectors. The output is dual mono

and is not affected by the MASTER volume

control or the EQ tone controls.

OUTPUT

The OUTPUT XLR provides balanced line

level signal.

NOTE: When wiring the LINE

output as unbalanced, Pin2

should be wired as hot and

Pin1 should be wired as

ground/shield. Do not wire Pin3.

24VDC SOCKET

This 2.1mm x 5.5mm barrel socket is

provided for 24V emergency systems and

is not switched by the front panel power

switch. Note:The 24VDC socket does not

provide trickle charge facility. Tip of the

connector is positive.

IEC MAINS INPUT SOCKET

This is a standard IEC 3 pin socket. It

accepts a standard IEC mains cable,

provided. The fuse draw contains the

mains fuse and a spare. The mains fuse is

a time lag (slow blow) HRC 20mm x 5mm

ceramic type fuse.

The ratings are:

230V/240V model 63mA

115V model 120mA

Always replace the fuse with

one of the same value and type.

NOTE: Always disconnect

power to the amplifier before

replacing fuses.

OPTIONAL MODULE INPUTS

This socket is used with a tone module

and/or VCA module.

1

2

3

5

6

4

5

4

6 3 2

☛

1

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire